Engine [Rider, Walker] ....

---

What do I do...

 

If the rope will not pull out? [Rider, Walker]

 

Stop lever is not pulled back or cable is not properly assembled.

If the engine smokes (blue smoke)? [Rider, Walker]

 

Check oil level. If okay, let run for several minutes. Sometimes oil gets into cylinder during shipment.

If the mower vibrates excessively? [Rider, Walker]

 

Check for bent blade. If not bent, have authorized service dealer check for bent crankshaft.

If the engine will not start? [Rider, Walker]

1. Check starting procedure. Make sure starting instructions are followed.
2. Prime engine (push primer button). Check for water in fuel tank. Make sure fuel is fresh.

 

If the engine will not turn over? [Rider]

1. Check starting procedure. Make sure starting instructions are followed.
2. Check fuse (if equipped). See Wiring Diagram or Schematic section in manual or Repair Parts book.
3. Check battery for charge. Make sure battery has been activated and charged (on new units).
4. On new units, remove spark plug and check cylinder for accumulation of oil due to improper handling.
5. Make a visual inspection of the electrical system to make sure all connection and lockout switches are secure.
   (See Wiring Diagram or Schematic section in manual or Repair Parts book.)
6. Check engine according to engine manufacturers instructions.
7. Have the wiring and lockout switches checked by an authorized service dealer.

 

If the engine turns over but will not start? [Rider, Walker]

1. Check starting procedure. Make sure starting instructions are followed.
2. Make sure fuel tank is filled with clean, fresh gasoline.
3. Make sure fuel shut-off is open (if equipped).
4. Make sure throttle is in START or FAST position.
5. Check engine according to engine manufacturer's instructions.
6. Have the wiring and lockout switches checked by an authorized service dealer.
7. Check fuel filter for obstructions.

Return to list